Mount the battery to your vehicle in a secure location. When you are ready to power your video system, attach a battery to the red connector. Wire and mount transmitter battery Connect the red and black two-wire cable to the transmitter. Ensure that the components are placed where the connectors will reach between them, and where the MinimOSD can reach the autopilot. Mount components to vehicle Place and mount the camera, MinimOSD board, and transmitter to your vehicle. Connect the telemetry radio air module to Pixhawk’s TELEM 1 port using the four-position cable provided with the radios. Wire onboard components: Pixhawk and 3DR Radio V2 Connect the OSD board to Pixhawk’s TELEM 2 port using the FTDI-to-DF13 cable included with this kit. Connect the 3DR Radio to the connector labeled RADIO with the red wire connected to the 5V pin. Wire onboard components: APM and 3DR Radio V1 Connect the OSD and 3DR Radio to the APM Telem port using the DF13 to FTDI y-cable.Ĭonnect the five-position connector to the APM Telem port and the OSD connector to the six pins on the OSD labeled GRN, TX, RX, +5V, GND, and BLK with the black wire connected to pin marked BLK. Connect the 3DR Radio to the six-position connector. Wire onboard components: APM and 3DR Radio V2 Connect the OSD and 3DR Radio to the APM Telem port using the DF13 to DF13 and FTDI y-cable.Ĭonnect the five-position connector to the APM Telem port and the FTDI connector to the six pins on the OSD labeled GRN, TX, RX, +5V, GND, and BLK with the black wire connected to pin marked BLK.
Connect the red, black, and white three-wire cable to the transmitter and to the three pins on the OSD labeled GND, +12V, and VOUT with the black wire connected to GND and the white wire connected to VOUT. This will allow you to mount the camera to your vehicle and adjust the angle of view.Ĭonnect camera and transmitter to OSD Connect the black, red, and yellow three-wire cable to the camera and to the three pins on the OSD labeled GND, +12V, and VIN with the black wire connected to GND and the yellow wire connected to VIN. Please see the section on page 7 for different options for viewing the video transmitted by your kit.Īttach camera mount Position mount over bottom of camera and attach through the two small holes on either side with the small screws. This kit does not include a device to view your video.
Thank you for purchasing a OSD/FPV Kit from 3D Robotics! Your new, lightweight video setup allows you to capture onboard video from your vehicle using a compact camera, overlay the video with important data from your autopilot, and transmit the video in flight.
#Arduino camera with osd plus#
Two antennas Two 2C 900 mAh LiPo batteriesĬamera mount with two screws plus two spares Transmitter cables
FPV/OSD KIT 3DR MinimOSD board OSD cables Digital video camera
0 kommentar(er)
